Gestetner G060 Service Manual page 1083

Firmware History for G060
DESCRIPTION OF MODIFICATION
The following have been corrected:
The target PM intervals for SP7-803 (PM
counter) have been changed as follows on China
models only.
PCU:
SP7-803-1--PCU [K] Target sheets: 25000
SP7-803-2, 3, 4--PCU [CMY] Target sheets: 25000
SP7-803-17--PCU [K] Target revolutions: 137669
SP7-803-18, 19, 20--PCU [CMY]
Target revolutions: 147953
Development Unit:
SP7-803-5--Dev [K] Target sheets: 50000
SP7-803-6, 7, 8--Dev [CMY] Target sheets: 50000
SP7-803-21--Dev [K] Target revolutions: 538051
SP7-803-22, 23, 24--Dev [CMY]
Target revolutions: 586693
Fusing Unit:
SP7-803-15--Fusing, Target sheets: 50000
SP7-803-26--Fusing, Target revolutions: 4651000
The target number revolutions for the Fusing
near end for SP-7-905-7 has been changed as
follows for the China models only.
Fusing: Alert
SP7-905-7 Fusing near end,
Target revolutions: 4418000
The following have been corrected:
Supports 2-level European cabinet paper
feeder:
Firmware modified so that if the destination code
is set to Europe, the paper will be exited from the
lower position whenever the Finisher and feed
station other than the paper feed unit is installed
(EU cabinet feeder is the same height as a 2-
level PFU, i.e. requires lower-position exit).
FIRMWARE SERIAL
LEVEL NUMBER
G0775623 F November
2002
G0775623 G December
2002
FIRMWARE CHECK
VERSION SUM
B1.23 3D1F
B1.24 514B
Page 6 of 16