Table of Contents
Advertisement
( F r o m p a g e 1 1 1 0 8 )
C h e c k t o r e s h o r t i n t h e P S P
switch:
1. Turn the ignition switch OFF.
2. Disconnect the 2P connector
from the PSP switch.
3. Turn the ignition switch ON (ll).
4. Measure voltage between ECM
c o n n e c t o r t e r m i n a l s C 1 6 a n d
A9.
Ch€ck for a short in the wire {PSP
SW lihell
1. Turn the ignition switch OFF.
2. Disconnect the ECM connec-
t o r C ( 3 1 P ) .
3. Check tor continuity between
body ground and ECM connec
t o r t e r m i n a l C l 6 .
ls there battery voltage?
ReDair short in the wire between
t h e E C M l C 1 6 ) a n d l h e P S P
switch.
Substituto a known-good ECM
and recheck. lf prescribed volt-
a96 is now available, replace the
originalECM.
A {32P)
ECM CONNECTORS
Wire side of temale terminals
c 13lPl
L G 1
{BRN/BLK)
PSP SW
IGRNI
1 1 - 1 0 9
Advertisement
Table of Contents
Troubleshooting
