Match Ip Access-Group - Dell Force10 MXL Blade Reference Manual

match ip access-group

Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
description
Syntax
Parameters
Defaults
Command Modes
Command
History
Related
Commands
470 | Quality of Service (QoS)
Configure match criteria for a class map, based on the access control list (ACL).
match ip access-group access-group-name [ set-ip-dscp value]
To remove ACL match criteria from a class map, use the no match ip access-group
access-group-name [ set-ip-dscp value]
access-group-name
set-ip-dscp value
none
CLASS-MAP CONFIGURATION (config-class-map)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
You must enter the class-map command in order to access this command. After the class map is
identified, you can configure the match criteria. For class-map match-any , a maximum of five ACL
match criteria are allowed. For class-map match-all , only one ACL match criteria is allowed.
class-map
Add a description to the selected policy map or QOS policy.
description { description }
To remove the description, use the no description {
description Enter a description to identify the policies (80 characters maximum).
none
CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in and
conf-qos-policy-out; wred)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
policy-map-input
policy-map-output
qos-policy-input
command.
Enter the ACL name whose contents are used as the match criteria in
determining if packets belong to the class specified by
(OPTIONAL) Enter the keyword
The matched traffic will be marked with the DSCP value.
Range: 0 to 63
Identifies the class map.
description
Creates an input policy map.
Creates an output policy map.
Creates an input QOS-policy on the router.
class-map
set-ip-dscp
followed by the IP DSCP value.
} command.
.