Clear Ip Dhcp; Debug Ip Dhcp Server - Dell Force10 MXL Blade Reference Manual

clear ip dhcp

Syntax
Parameters
Command Mode
Default
Command
History
Usage
Information

debug ip dhcp server

Syntax
Parameters
Command Mode
Default
Command
History
default-router
Syntax
Parameters
Command Mode
188 | Dynamic Host Configuration Protocol (DHCP)
Reset DHCP counters.
clear ip dhcp [binding { address} | conflict | server statistics]
binding
address
conflict
server statistics
EXEC Privilege
none
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Entering <CR> after clear ip dhcp binding , clears all the IPs from the binding table.
Display FTOS debugging messages for DHCP.
debug ip dhcp server [events | packets]
events Enter this keyword to display DHCP state changes.
packet Enter this keyword to display packet transmission/reception.
EXEC Privilege
none
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Assign a default gateway to clients based on address pool.
default-router address [ address2 ... address8 ]
address Enter the a list of routers that may be the default gateway for clients on the subnet. You may
specify up to 8. List them in order of preference.
DHCP <POOL>
Enter this keyword to delete all entries in the binding table.
Enter the IP address to clear the binding entry for a single IP address.
Enter this keyword to delete all of the log entries created for IP address
conflicts.
Enter this keyword to clear all the server counter information.