Show Ip Traffic - Dell Force10 MXL Blade Reference Manual

Example
Related
Commands

show ip traffic

Syntax
Command Modes
Command
History
318 | IPv4 Routing
Figure 15-20. show ip route summary Command Example
FTOS>show ip route summary
Route Source Active Routes
connected 17
static 3
ospf 100 1368
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
FTOS>
Table 15-10. show ip route summary Column Headings
Description
Column Heading
Route Source Identifies how the route is configured in FTOS.
Active Routes Identifies the best route if a route is learned from two protocol sources.
Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If the
best route or active route goes down, the non-active route will become the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Total 1388 active... Displays the number of active and non-active routes and the memory usage of those
routes.
If there are no routes configured in the FTOS, this line does not appear.
show ip route
View IP, ICMP, UDP, TCP, and ARP traffic statistics.
show ip traffic
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Non-active Routes
0
0
2
2
Displays information about the routes found in switch.