Show Debugging; Show Environment - Dell Force10 MXL Blade Reference Manual

Command
Version 8.3.16.1
History
Example Figure 4-11. show cpu-traffic-stats Command Example
FTOS#show cpu-traffic-stats
Processor : CP
--------------
FTOS#
Usage
Traffic statistics are sorted on a per-interface basis; the interface receiving the most traffic is displayed
Information
first. All CPU and port information is displayed unless a specific port or CPU is specified. Traffic
information is displayed for router ports only; not for management interfaces. The traffic statistics are
collected only after the
Related
debug cpu-traffic-stats
Commands

show debugging

View a list of all enabled debugging processes.
Syntax show debugging
Command Mode
EXEC Privilege
Command
Version 8.3.16.1
History
Example Figure 4-12. show debugging Command Example
FTOS#show debug
Generic IP:
OSPF:1
DHCP:
FTOS#

show environment

View system component status (for example, temperature, voltage).
Syntax
show environment [ all | stack-unit unit-id ]
Introduced on MXL 10/40GbE Switch IO Module
Received 100% traffic on TenGigabitEthernet 8/2
LLC:0, SNAP:0, IP:100, ARP:0, other:0
Unicast:100, Multicast:0, Broadcast:0
debug cpu-traffic-stats
Note:
After debugging is complete, use the
traffic statistics collection.
Introduced on MXL 10/40GbE Switch IO Module
(Access List: test)
IP packet debugging is on for
TenGigabitEthernet 0/16
ICMP packet debugging is on for
TenGigabitEthernet 0/16
OSPF packet debugging is on
DHCP debugging is on
command is executed; not from the system bootup.
no debug cpu-traffic-stats
Enables CPU traffic statistics for debugging.
(Access List: test)
Total packets:100
command to shut off
Control and Monitoring | 59