Match Mac Dot1P; Match Mac Vlan - Dell Force10 MXL Blade Reference Manual

match mac dot1p

Configure a match criterion for a class map, based on a dot1p value.
Syntax match mac dot1p { dot1p-list }
Parameters
dot1p-list
Defaults
none
Command Modes CLASS-MAP
Command
Version 8.3.16.1
History
Usage You must enter the class-map command in order to access this command. After the class map is
Information
identified, you can configure the match criteria.
Related
class-map
Commands

match mac vlan

Configure a match criterion for a class map based on VLAN ID.
Syntax match mac vlan number
Parameters
number
Defaults none
Command Modes
CLASS-MAP
Command
Version 8.3.16.1
History
Usage You must first enter the class-map command in order to access this command. You can match against
Information
only one VLAN ID.
Related
class-map
Commands
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is
part of the policy map (input/output) applied on an interface.
Syntax policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate qos-policy-name command.
Enter a dot1p value.
Range: 0 to 7
Introduced on MXL 10/40GbE Switch IO Module
Identifies the class map.
Enter the VLAN ID.
Range: 1 to 4094
Introduced on MXL 10/40GbE Switch IO Module
Creates/accesses a class map.
Quality of Service (QoS) | 473