Dell Force10 MXL Blade Reference Manual page 246

Parameters
Defaults
Command Modes
Command
History
Usage
Information
Example
Example
246 | Interfaces
interface ,
Enter the keyword
.. port-channel or VLAN number. Select the range of interfaces for bulk configuration.
interface ,.
You can enter up to six comma separated ranges—spaces are not required between the
commas. Comma-separated ranges can include VLANs, port-channels and physical
interfaces.
Slot/Port information must contain a space before and after the dash. For example,
interface range tengigabitethernet 0/1 - 5
tengigabitethernet 0/1-5
• For a Port Channel interface, enter the keyword
number:
Range: 1 to 128
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
slot/port information.
• For a VLAN, enter the keyword
none
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
When creating an interface range, interfaces appear in the order they are entered; they are not sorted.
The command verifies that interfaces are present (physical) or configured (logical). Important things to
remember:
• Bulk configuration is created if at least one interface is valid.
• Non-existing interfaces are excluded from the bulk configuration with a warning message.
• The interface range prompt includes interface types with slot/port information for valid interfaces.
The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds 32
characters, it is represented by an ellipsis ( ... ).
• When the interface range prompt has multiple port ranges, the smaller port range is excluded from
the prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest start port and the
biggest end port.
Figure 14-11. Bulk Configuration Warning Message
FTOS(conf)#interface range so 2/0 - 1 , te 10/0 , tengig 3/0
0
% Warning: Non-existing ports (not configured) are ignored by
Figure 14-12. Interface Range prompt with Multiple Ports
FTOS(conf)#interface range tengig 2/0 - 23 , tengig 2/1 - 10
FTOS(conf-if-range-tengig-2/0-23#
interface range
and one of the interfaces — slot/port,
is not valid.
vlan
followed by a number from 1 to 4094.
interface range
is valid;
port-channel
followed by a
TenGigabitEthernet
fortyGigE
followed by the
, fa 0/