Show Config (From Interface Range Mode) - Dell Force10 MXL Blade Reference Manual

rate-interval
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
show config
Syntax
Command Modes
Command
History
Example

show config (from INTERFACE RANGE mode)

Syntax
Command Modes
258 | Interfaces
Configure the traffic sampling interval on the selected interface.
rate-interval seconds
seconds
Enter the number of seconds for which to collect
Range: 5 to 299 seconds
Note: For 0-5 seconds, polling occurs every 5 seconds. For 6-10 seconds, polling
occurs every 10 seconds. For any other value, polling occurs every 15 seconds.
299 seconds
INTERFACE
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
The configured rate interval is displayed, along with the collected traffic data, in the output of show
interfaces commands.
show interfaces
Display the interface configuration.
show config
INTERFACE
Version 8.3.16.1
Figure 14-26. show config Command Example for the INTERFACE Mode
FTOS(conf-if)#show conf
!
interface TenGigabitEthernet 1/7
no ip address
switchport
no shutdown
FTOS(conf-if)#
Display the bulk configured interfaces
show config
CONFIGURATION INTERFACE (conf-if-range)
Displays information on physical and virtual interfaces.
Introduced on MXL 10/40GbE Switch IO Module
(interface range).
traffic
data.