Protocol Lldp (Interface) - Dell Force10 MXL Blade Reference Manual

Command Modes
Command
History
Related
Commands
multiplier
Syntax
Parameters
Defaults
Command Modes
Command
History
protocol lldp (Configuration)
Syntax
Defaults
Command Modes
Command
History

protocol lldp (Interface)

Syntax
Defaults
360 | Link Layer Discovery Protocol (LLDP)
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
protocol lldp (Configuration)
show lldp neighbors
Set the number of consecutive misses before LLDP declares the interface dead.
multiplier integer
To return to the default, use the
integer Enter the number of consecutive misses before the LLDP declares the interface dead.
Range: 2 - 10
4 x hello
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Version 8.3.16.1
Enable LLDP globally on the switch.
protocol lldp
To disable LLDP globally on the chassis, use the
Disabled
CONFIGURATION (conf-lldp)
Version 8.3.16.1
Enter the LLDP protocol in the INTERFACE mode.
[ no ] protocol lldp
To return to the global LLDP configuration mode, use the
mode.
LLDP is not enabled on the interface.
Enables LLDP globally.
Displays the LLDP neighbors
no multiplier integer command.
Introduced on MXL 10/40GbE Switch IO Module
no protocol lldp
Introduced on MXL 10/40GbE Switch IO Module
no protocol lldp
command.
command from the Interface