Ntp Broadcast Client; Ntp Authentication-Key - Dell Force10 MXL Blade Reference Manual

ntp authentication-key

Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands

ntp broadcast client

Syntax
Defaults
Command Modes
Command
History
638 | System Time and Date
Specify a key for authenticating the NTP server.
ntp authentication-key number md5
number Specify a number for the authentication key.
Range: 1 to 4294967295.
This number must be the same as the number parameter configured in the
command.
md5 Specify that the authentication key will be encrypted using MD5 encryption algorithm.
0 Specify that authentication key will be entered in an unencrypted format (default).
7 Specify that the authentication key will be entered in DES encrypted format.
key
Enter the authentication key in the previously specified format.
NTP authentication is not configured by default. If you do not specify the option [
default.
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
After configuring the ntp authentication-key
ntp trusted-key command.
FTOS versions 8.2.1.0 and later use an encryption algorithm to store the authentication key that is
different from previous FTOS versions; beginning in version 8.2.1.0, FTOS uses DES encryption to
store the key in the startup-config when you enter the command
your system boots with a startup-configuration from an FTOS versions prior to 8.2.1.0 in which you
have configured ntp authentication-key
authenticate NTP packets. In this case you must re-enter this command and save the running-config to
the startup-config.
ntp authenticate
ntp trusted-key
Set up the interface to receive NTP broadcasts from an NTP server.
ntp broadcast client
To disable broadcast, use the
Disabled
INTERFACE
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
[ | ] key
0 7
command, to complete NTP authentication, configure the
, the system cannot correctly decrypt the key, and cannot
Enables NTP authentication.
Configures a trusted key.
no ntp broadcast client command.
ntp trusted-key
| ], 0 is selected by
0 7
. Therefore, if
ntp authentication-key