Debug Uplink-State-Group - Dell Force10 MXL Blade Reference Manual

Parameters
Command Modes
Command
History
Related
Commands

debug uplink-state-group

Syntax
Parameters
Defaults
Command Modes
Command
History
Related
Commands
646 | Uplink Failure Detection (UFD)
interface interface
uplink-state-group
group-id
EXEC Mode
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
downstream
upstream
uplink-state-group
Enable debug messages for events related to a specified uplink-state group or all groups.
debug uplink-state-group [group-id]
To turn off debugging event messages, use the no debug uplink-state-group [group-id] command.
group-id Enables debugging on the specified uplink-state group. Valid group-id values
are 1 to 16.
none
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
clear ufd-disable
Specifies one or more downstream interfaces.
For interface, enter one of the following interface types:
10-Gigabit Ethernet: tengigabitethernet {slot/port |slot/port-range}
40-Gigabit Ethernet: fortygigabitethernet {slot/port |slot/port-range}
Port channel: port-channel {1-512 | port-channel-range}
Where port-range and port-channel-range specify a range of ports
separated by a dash (-) and/or individual ports/port channels in any
order; for example:
tengigabitethernet 1/1-2,5,9,11-12
port-channel 1-3,5
A comma is required to separate each port and port-range entry.
Re-enables all UFD-disabled downstream interfaces in the group.
Valid group-id values are 1 to 16.
Assigns a port or port-channel to the uplink-state group as a downstream
interface.
Assigns a port or port-channel to the uplink-state group as an upstream interface.
Creates an uplink-state group and enable the tracking of upstream links.
Re-enables downstream interfaces that are in a UFD-disabled error state.