Protocol Spanning-Tree - Dell Force10 MXL Blade Reference Manual

Command
History
Version 8.3.16.1

protocol spanning-tree

Enter SPANNING TREE mode to enable and configure the spanning tree group.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, use the no protocol spanning-tree stp-id command.
Parameters
stp-id
Defaults Not configured.
Command Modes
CONFIGURATION
Command
Version 8.3.16.1
History
Example Figure 34-1. protocol spanning-tree Command Example
FTOS(conf)#protocol spanning-tree 0
FTOS(conf-stp)#
Usage STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch,
Information
use the
Related
disable
Commands
show config
Display the current configuration for the mode. Only non-default values are displayed.
show config
Syntax
Command Modes
SPANNING TREE
Command
Version 8.3.16.1
History
Example Figure 34-2. show config Command Example
FTOS(conf-stp)#show config
protocol spanning-tree 0
FTOS(conf-stp)#
Introduced on MXL 10/40GbE Switch IO Module
Enter zero (0). FTOS supports one Spanning Tree group, group 0.
Introduced on MXL 10/40GbE Switch IO Module
no disable command from SPANNING TREE mode.
Disables spanning tree group 0. To enable spanning tree group 0, use the
command.
Introduced on MXL 10/40GbE Switch IO Module
no disable
no disable
Spanning Tree Protocol (STP) | 625