Iscsi Aging Time; Iscsi Cos - Dell Force10 MXL Blade Reference Manual

iscsi aging time

Syntax
Parameters
Defaults
Command Mode
Command
History

iscsi cos

Syntax
Parameters
Defaults
Command Modes
Command
History
324 | iSCSI Optimization
Set the aging time for iSCSI sessions.
iscsi aging time time
To remove the iSCSI session aging time, use the
time Enter the aging time for the iSCSI session.
Valid values: 5 to 43,200 minutes.
10 minutes.
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Set the QoS policy that will be applied to the iSCSI flows.
iscsi cos {enable | disable | dot1p vlan-priority-value [remark] | dscp dscp-value [remark]}
To disable the QoS policy, use the
enable
Enter the keyword
iSCSI traffic so that the iSCSI packets are scheduled in the switch with a dot1p
priority 4 regardless of the VLAN priority tag in the packet.
Default: iSCSI packets are handled with dotp1 priority 4 without remark.
disable
Enter the keyword
to iSCSI frames.
dot1p
Enter the dot1p value of the VLAN priority tag assigned to the incoming packets in
vlan-priority-value an iSCSI session.
The valid range is 0 to 7.
Default: The dot1p value in ingress iSCSI frames is not changed and is used in
iSCSI TLV advertisements if you did not enter the
dscp dscp-value
Enter the DSCP value assigned to the incoming packets in an iSCSI session.
The valid range is 0 to 63.
Default: The DSCP value in ingress packets is not changed.
remark
Marks the incoming iSCSI packets with the configured dot1p or DSCP value when
they egress to the switch.
Default: The dot1and DSCP values in egress packets are not changed.
See above.
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
no iscsi aging time
no iscsi cos dscp command.
enable
to allow the application of preferential QoS treatment to
disable
to disable the application of preferential QoS treatment
command.
iscsi priority-bits
command.