Standard Mac Acl Commands - Dell Force10 MXL Blade Reference Manual

Standard MAC ACL Commands

deny
Syntax
Parameters
Defaults
Command Modes
Command
History
Related
Commands
120 | Access Control Lists (ACL)
When an access-list is created without any rule and then applied to an interface, ACL behavior reflects
implicit permit.
The MXL 10/40GbE Switch IO Module platform supports both ingress and egress MAC ACLs.
The following commands configure standard MAC ACLs:
• deny
• mac access-list standard
• permit
• seq
Note:
See also Commands Common to all ACL Types
Commands.
Configure a filter to drop packets with a the MAC address specified.
deny { any | mac-source-address [ mac-source-address-mask ]} [ count [ byte ]]
To remove this filter, you have two choices:
• Use the no seq sequence-number
• Use the no deny { any |
any
mac-source-address
mac-source-address-mask
count
byte
Not enabled.
CONFIGURATION-MAC ACCESS LIST-STANDARD
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
permit Configures a MAC address filter to pass packets.
seq Configures a MAC address filter with a specified sequence number.
command if you know the filter's sequence number.
mac-source-address mac-source-address-mask
Enter the keyword
filter.
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
(OPTIONAL) Specify which bits in the MAC address must match. If
no mask is specified, a mask of 00:00:00:00:00:00 is applied (in
other words, the filter allows only MAC addresses that match).
(OPTIONAL) Enter the keyword
by the filter.
(OPTIONAL) Enter the keyword
the filter.
and Common MAC Access List
} command.
any
to specify that all traffic is subject to the
count
to count packets processed
byte
to count bytes processed by