Dell Force10 MXL Blade Reference Manual page 53

Parameter
host
ip-address
count
datagram size
timeout
source
tos
df-bit
validate-reply
pattern pattern
sweep-min-size
sweep-max-size
(OPTIONAL) Enter the host name of the devices to which you are testing
connectivity.
(OPTIONAL) Enter the IPv4 address of the device to which you are testing
connectivity. The address must be in the dotted decimal format.
Enter the number of echo packets to be sent.
number
: 1- 2147483647
Continuous
: transmit echo request continuously
Default: 5
Enter the ICMP datagram size.
Range: 36 - 15360 bytes
Default: 100
Enter the interval to wait for an echo reply before timing out.
Range: 0 -3600 seconds
Default: 2 seconds
Enter the IPv4 source ip address or the source interface.
• Enter the IP address in A.B.C.D format
• For a Port Channel interface, enter the keyword
number:
Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
the slot/port information.
• For a VLAN interface, enter the keyword
4094.
Enter the type of service required.
Range: 0-255
Default: 0
Enter Y or N for the don't fragment bit in IPv4 header
• N: Do not set the don't fragment bit
• Y: Do set don't fragment bit
Default is No.
Enter Y or N for reply validation.
• N: Do not validate reply data
• Y: Do validate reply data
Default is No.
Enter the IPv4 data pattern.
Range: 0-FFFF
0xABCD
Default:
Enter the minimum size of datagram in sweep range.
Range: 52-15359 bytes
Enter the maximum size of datagram in sweep range.
Range: 53-15359 bytes
port-channel
followed by a
TenGigabitEthernet
fortyGigE
followed by
vlan
followed by a number from 1 to
Control and Monitoring | 53