Show Interfaces Configured - Dell Force10 MXL Blade Reference Manual
Ftos command line reference guide for the mxl 10/40gbe switch io module
Hide thumbs
Also See for Force10 MXL Blade:
- Configuration manual (690 pages) ,
- Deployment manual (89 pages) ,
- Getting started manual (38 pages)
Table of Contents
Advertisement
Related
show interfaces configured
Commands
show interfaces stack-unit
strict-priority unicast
show interfaces switchport
show inventory
show ip interface
show memory
show range
show interfaces configured
Display any interface with a non-default configuration.
Syntax
show interfaces configured
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.16.1
History
Example
Figure 14-31. show interfaces configured Command Example
FTOS#show interfaces configured
TenGigabitEthernet 13/18 is up, line protocol is up
Hardware is DellForce10Eth, address is 00:01:e8:05:f7:fc
Interface index is 474791997
Internet address is 1.1.1.1/24
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex, Master
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interfaces" counters 00:12:42
Queueing strategy: fifo
Input Statistics:
Output Statistics:
Rate info (interval 299 seconds):
Time since last interface status change: 00:04:59
FTOS#
Related
show interfaces
Commands
Introduced on MXL 10/40GbE Switch IO Module
Current address is 00:01:e8:05:f7:fc
10 packets, 10000 bytes
0 Vlans
0 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 10 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 0 Broadcasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
1 packets, 64 bytes, 0 underruns
1 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte pkts
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte pkts
0 Multicasts, 1 Broadcasts, 0 Unicasts
0 Vlans, 0 throttles, 0 discarded, 0 collisions
Input 00.00 Mbits/sec,
Output 00.00 Mbits/sec,
Displays information on a specific physical interface or virtual interface.
Displays any interface with a non-default configuration.
Displays information on all interfaces on a specific stack unit.
Displays information of either rate limiting or rate policing on the interface.
Displays Layer 2 information about the interfaces.
Displays the MXL switch type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
Displays Layer 3 information about the interfaces.
Displays the stack unit(s) status.
Displays all interfaces configured using the interface range command.
0 packets/sec, 0.00% of line-rate
0 packets/sec, 0.00% of line-rate
Interfaces | 263
Advertisement
Table of Contents
