Undebug All - Dell Force10 MXL Blade Reference Manual

undebug all

Syntax
Defaults
Command Modes
Command
History
virtual-ip
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Example
write
Syntax
Parameters
78 | Control and Monitoring
Disable all debug operations on the system.
undebug all
none
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Configure a virtual IP address for the active management interface. You can configure virtual
addresses for IPv4 independently.
virtual-ip { ipv4-address }
{ ipv4-address }
none
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Each time this command is issued, it replaces the previously configured address of the same family.
The no virtual-ip command now takes an address/prefix-length argument, so that the desired address
only is removed. If you use the no virtual-ip command without any specified address, the IPv4 virtual
addresses are removed.
Figure 4-33. virtual ip (IPv4) Command Example
FTOS#virtual-ip 10.11.197.99/16
Copy the current configuration to either the startup-configuration file or the terminal.
write { memory | terminal }
memory
Enter the keyword
configuration file. This command is similar to the
command.
terminal
Enter the keyword
command is similar to the
Enter the IPv4 address (A.B.C.D) of the active management interface.
memory
to copy the current running configuration to the startup
terminal
to copy the current running configuration to the terminal. This
show running-config
copy running-config startup-config
command.