Dell Force10 MXL Blade Reference Manual page 623

disable
Disable the spanning tree protocol globally on the switch.
Syntax
disable
To enable STP, use the no disable command.
Defaults Enabled (that is, the spanning tree protocol is disabled.)
Command Modes
SPANNING TREE
Command
Version 8.3.16.1
History
Related
portfast bpdufilter default
Commands
forward-delay
The amount of time the interface waits in the Listening State and the Learning State before
transitioning to the Forwarding State.
Syntax
forward-delay seconds
To return to the default setting, use the no forward-delay command.
Parameters
seconds
Defaults
15 seconds
Command Modes SPANNING TREE
Command
Version 8.3.16.1
History
Related
max-age
Commands
hello-time
hello-time
Set the time interval between generation of the spanning tree bridge protocol data units (BPDUs).
Syntax
hello-time seconds
To return to the default value, use the no hello-time command.
Introduced on MXL 10/40GbE Switch IO Module
Enters SPANNING TREE mode.
Enter the number of seconds the FTOS waits before transitioning STP to the
forwarding state.
Range: 4 to 30
Default: 15 seconds.
Introduced on MXL 10/40GbE Switch IO Module
Changes the wait time before STP refreshes protocol configuration information.
Changes the time interval between BPDUs.
Spanning Tree Protocol (STP) | 623