Show Reload-Type - Dell Force10 MXL Blade Reference Manual

reload-type
Syntax
Parameters
Defaults
Command Modes
Command
History

show reload-type

Syntax
Command Modes
Command
History
show boot jumpstart
Syntax
Command Modes
144 | Bare Metal Provisioning
Reload the system using the specified start-up mode.
reload-type [normal | jump-start auto-save [enable | disable] dhcp-timeout {minutes}
config-download [enable | disable]]
normal
jump-start
dhcp-timeout
config-download
auto-save
jump-start
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Display the reload type currently configured on the system.
show reload-type
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Display the jumpstart status at any instant.
show boot jumpstart
EXEC Privilege
Enable the normal reload type. The system retrieves the FTOS image and
start-up configuration files from the flash.
Enable the BMP reload type. The system acts as a DHCP client and
downloads the FTOS image and configuration and boot files from a
specified DHCP server.
Set the amount of time the system waits for a DHCP server response before
reverting to normal reload type.
Range: 1-50 minutes
Default: infinity
The default time is infinity; if no time is set, the system continues to wait
unless the stop jump-start command is given.
Note: Dell Force10 recommends setting the value to 2 or higher.
Specify if the system should download a configuration file from the DHCP
server or use the start-up configuration files from the flash.
Enable: Download the configuration files from the server.
Disable: Use the local start-up configuration files.
Configure the auto save option for the downloaded configuration file.