Dell Force10 MXL Blade Reference Manual page 77

Usage This command enables XML input mode where you can either cut and paste XML requests or enter the
Information
XML requests line-by-line. For more information about using the XML feature, refer to the XML
chapter in the FTOS Configuration Guide.
traceroute
View the packet path to a specific device.
Syntax
traceroute { host | ip-address }
Parameters
host
ip-address
Defaults
Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434
Command Modes EXEC
EXEC Privilege
Command
Version 8.3.16.1
History
Usage When you enter the traceroute command without specifying an IP address (Extended Traceroute), you
Information
are prompted for a target and source IP address, timeout in seconds (default is 5), a probe count
(default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is
33434). To keep the default setting for those parameters, press the ENTER key.
Example Figure 4-32. traceroute (IPv4) Command Example
Related
ping
Commands
Enter the name of device.
Enter the IP address of the device in dotted decimal format.
Introduced on MXL 10/40GbE Switch IO Module
FTOS#traceroute www.force10networks.com
Translating "www.force10networks.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
---------------------------------------------------------------------------------
---------
Tracing the route to www.force10networks.com (10.11.84.18), 30 hops max, 40 byte
packets
---------------------------------------------------------------------------------
---------
TTL Hostname
1 10.11.199.190
2 gwegress-sjc-02.force10networks.com (10.11.30.126) 005.000 ms
001.000 ms
3 fw-sjc-01.force10networks.com (10.11.127.254) 000.000 ms 000.000 ms 000.000
ms
Tests the connectivity to a device.
Probe1 Probe2
001.000 ms 001.000 ms
Probe3
002.000 ms
001.000 ms
Control and Monitoring | 77