Source (Port Monitoring) - Dell Force10 MXL Blade Reference Manual

source (port monitoring)

Configure a port monitor source.
Syntax source interface destination interface direction
To disable a monitor source, use the no source interface destination interface direction { rx | tx | both }
command
Parameters
interface
destination
direction {rx | tx | both}
Defaults none
Command Modes
MONITOR SESSION (conf-mon-sess-session-ID)
Command
Version 8.3.16.1
History
Example Figure 22-5. Configuring a Port Monitor Source Command Example
FTOS(conf-mon-sess-11)#source tengig 10/0 destination tengig 10/47 direction
rx
FTOS(conf-mon-sess-11)#
.
Enter the one of the following keywords and slot/port information:
•
•
Enter the keyword
Enter the keyword
indicators.
rx
tx
both
Introduced on M I/O Aggregator
{ rx | tx | both }
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
For a 40-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
destination
direction
followed by one of the packet directional
: to monitor receiving packets only
: to monitor transmitting packets only
: to monitor both transmitting and receiving packets
fortyGigE
to indicate the interface destination.
Port Monitoring | 437