Vrrp Delay Minimum - Dell Force10 MXL Blade Reference Manual

Ftos command line reference guide for the mxl 10/40gbe switch io module

Hide thumbs Also See for Force10 MXL Blade:

Table of Contents

virtual-address

Command Modes

vrrp delay minimum

Command Modes

Virtual Router Redundancy Protocol (VRRP)

Configure up to 12 IP addresses of virtual routers in the VRRP group. You must set at least one virtual

address for the VRRP group to start sending VRRP packets.

virtual-address ip-address1 [... ip-address12 ]

To delete one or more virtual IP addresses, use the no virtual-address

Enter an IP address of the virtual router in dotted decimal format.

The IP address must be on the same subnet as the interface's primary IP address.

ip-address12

(OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted

decimal format. Separate the IP addresses with a space.

The IP addresses must be on the same subnet as the interface's primary IP address.

Not configured.

Version 8.3.16.1

Introduced on MXL 10/40GbE Switch IO Module

The VRRP group only becomes active and sends VRRP packets when a virtual IP address is

configured. When you delete the virtual address, the VRRP group stops sending VRRP packets.

A system message appears after you enter or delete the

To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with

the same IP address as the interface's primary IP address and change the

You can ping the virtual addresses configured in all VRRP groups.

Set the delay time for VRRP initialization after an interface comes up.

vrrp delay minimum seconds

Enter the number of seconds for the delay for VRRP initialization after an interface

becomes operational.

Range: 0 to 900 (0 indicates no delay)

Version 8.3.16.1

Introduced on MXL 10/40GbE Switch IO Module

virtual-address

of the VRRP group to

ip-address12