Dell Force10 MXL Blade Reference Manual page 207

fip-snooping enable
Enable FIP snooping on all VLANs or on a specified VLAN.
fip-snooping enable
Syntax
To disable the FIP snooping feature on all or a specified VLAN, use the no fip-snooping enable
command.
Defaults
FIP snooping is disabled on all VLANs.
Command Modes •
•
Command
Version 8.3.16.1
History
Usage
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four. The maximum
Information
number of FIP snooping sessions supported per ENode server is 16.
fip-snooping fc-map
Configure the FC-MAP value used by FIP snooping on all VLANs.
Syntax fip-snooping fc-map fc-map-value
To remove the configured FM-MAP value, use the no fip-snooping fc-map command.
Parameters
fc-map-value
Defaults
0x0EFC00
Command Mode •
•
Command
Version 8.3.16.1
History
fip-snooping port-mode fcf
Configure the port for bridge-to-FCF links.
Syntax fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-mode fcf command.
Command Modes
INTERFACE
Command
Version 8.3.16.1
History
Usage
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
Information
CONFIGURATION
VLAN INTERFACE
Introduced on MXL 10/40GbE Switch IO Module
Enter the FC-MAP value used by FIP snooping.
The valid values are from 0EFC00 to 0EFCFF.
CONFIGURATION
VLAN INTERFACE
Introduced on MXL 10/40GbE Switch IO Module
Introduced on MXL 10/40GbE Switch IO Module
FIP Snooping | 207