Dell Force10 MXL Blade Reference Manual page 614

Example
Related
Commands
show system stack-ports
Syntax
Parameters
Defaults
Command Modes
Command
History
614 | Stacking Commands
Figure 33-2. show redundancy Command Example
FTOS#show redundancy
-- Stack-unit Status
------------------------------------------------
Mgmt ID:
Stack-unit ID:
Stack-unit Redundancy Role:
Stack-unit State:
Stack-unit SW Version:
Link to Peer:
Peer Stack-unit:
-- Stack-unit Redundancy Configuration
------------------------------------------------
Primary Stack-unit:
Auto Data Sync:
Failover Type:
Auto reboot Stack-unit:
Auto failover limit:
-- Stack-unit Failover Record
------------------------------------------------
Failover Count:
Last failover timestamp:
Last failover Reason:
Last failover type:
-- Last Data Block Sync Record:
------------------------------------------------
Stack Unit Config:
Start-up Config:
Runtime Event Log:
Running Config:
ACL Mgr:
LACP:
STP:
SPAN:
FTOS#
redundancy disable-auto-reboot
Display information about the stacking ports on all switches in the MXL 10/40GbE switch stack.
show system stack-ports [ status | topology ]
status
(OPTIONAL) Enter the keyword
Connection field.
topology
(OPTIONAL) Enter the keyword
Connection fields.
none
EXEC
EXEC Privilege
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
--
0
0
Primary
Active
E8-3-16-160
Down
not present
--
mgmt-id
Full
Hot Failover
Enabled
3 times in 60 minutes
--
0
None
None
None
--
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
no block sync done
Prevents the system from auto-rebooting if it fails.
status
topology
0
to display the command output without the
to limit the table to just the Interface and