Show Interfaces - Dell Force10 MXL Blade Reference Manual
Ftos command line reference guide for the mxl 10/40gbe switch io module
Hide thumbs
Also See for Force10 MXL Blade:
- Configuration manual (690 pages) ,
- Deployment manual (89 pages) ,
- Getting started manual (38 pages)
Table of Contents
Advertisement
Command
Version 8.3.16.1
History
Example
Figure 14-27. show config (Bulk Configuration) Command Example
FTOS(conf)#interface range tengigabitethernet 1/1 - 2
FTOS(conf-if-range-tengig-1/1-2)#show config
!
interface TenGigabitEthernet 1/1
!
interface TenGigabitEthernet 1/2
FTOS(conf-if-range-tengig-1/1-2)#
show interfaces
Display information on a specific physical interface or virtual interface.
Syntax
show interfaces interface
Parameters
interface
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.16.1
History
Usage
Use this show interfaces command for details on a specific interface. Use the show interfaces
stack-unit command for details on all interfaces on the designated stack unit.
On the MXL Switch, the show interface output displays incorrect rate information details over time for
link monitoring when the rate-interval is configured for 5 seconds. Dell Force10 recommends using
higher rate-intervals such as 15 to 299 seconds to minimize the errors seen.
Introduced on MXL 10/40GbE Switch IO Module
no ip address
switchport
no shutdown
no ip address
switchport
no shutdown
Enter one of the following keywords and slot/port or number information:
•
For a Loopback interface, enter the keyword
16383.
•
For the management interface, enter the keyword
the slot/port information. The slot range is 0 to 1 and the port range is 0.
•
For a Null interface, enter the keywords
•
For a Port Channel interface, enter the keyword
Range: 1 to 128
•
For a 10-Gigabit Ethernet interface, enter the keyword
the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
information.
•
For a VLAN interface, enter the keyword
Introduced on MXL 10/40GbE Switch IO Module
Note:
In the CLI output, the power value will be rounded to a 3-digit value. For receive/
transmit power that is less than 0.000, an snmp query will return the corresponding dbm value
even though the CLI displays as 0.000.
loopback
followed by a number from 0 to
ManagementEthernet
null 0
.
port-channel
followed by a number:
TenGigabitEthernet
fortyGigE
followed by the slot/port
vlan
followed by a number from 1 to 4094.
followed by
followed by
Interfaces | 259
Advertisement
Table of Contents
