Interface Null; Interface Range - Dell Force10 MXL Blade Reference Manual

The Management port is enabled by default (no shutdown). Use the
IP address to the Management port.
Related
management route
Commands
duplex (1000/10000 Interfaces)

interface null

Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number
Defaults
Not configured; number = 0
Command Modes CONFIGURATION
Command
Version 8.3.16.1
History
Example Figure 14-10. interface null Command Example
FTOS(conf)#interface null 0
FTOS(conf-if-nu-0)#
Usage You cannot delete the Null interface. The only configuration command possible in a Null interface is
Information
unreachables.
Related
interface
Commands
interface loopback
interface port-channel
interface vlan
ip unreachables

interface range

This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
Syntax interface range interface , interface ,. ..
Configure a static route that points to the Management interface or a
forwarding router.
Configure duplex mode on any physical interfaces where the speed is set
to 1000/10000
Enter zero (0) as the Null interface number.
Introduced on MXL 10/40GbE Switch IO Module
Configures a physical interface.
Configures a Loopback interface.
Configures a port channel.
Configures a VLAN.
Enables generation of ICMP unreachable messages.
ip address command to assign an
Interfaces | 245
ip