Dell Force10 MXL Blade Reference Manual page 359

disable
Enable or disable LLDP.
Syntax disable
To enable LLDP, use the no disable
Defaults Enabled, that is no disable
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
Version 8.3.16.1
History
Related
protocol lldp (Configuration)
Commands
debug lldp interface
show lldp neighbors
show running-config lldp
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults
30 seconds
Command Modes
CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
Version 8.3.16.1
History
mode
Set LLDP to receive or transmit.
Syntax mode
To return to the default, use the no mode { tx | rx } command.
Parameters
tx
rx
Defaults Both transmit and receive
Introduced on MXL 10/40GbE Switch IO Module
Enables LLDP globally.
Debugs LLDP
Displays the LLDP neighbors
Displays the LLDP running configuration
Enter the rate, in seconds, at which the control packets are sent to its peer.
Rate: 5 to 180 seconds
Default: 30 seconds
Introduced on MXL 10/40GbE Switch IO Module
{ tx | rx }
Enter the keyword
Enter the keyword
tx
to set the mode to transmit.
rx
to set the mode to receive.
Link Layer Discovery Protocol (LLDP) | 359