Dell Force10 MXL Blade Reference Manual page 170

Command Modes
Command
History
Usage
Information
Related
Commands
qos-policy-output ets
Syntax
Parameters
Command Modes
Command
History
Usage
Information
Related
Commands
scheduler
Syntax
170 | Data Center Bridging
PRIORITY-GROUP
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
By default:
• All 802.1p priorities are grouped in priority group 0.
• 100% of the port bandwidth is assigned to priority group 0. The complete bandwidth is equally
assigned to each priority class so that each class has 12-13%.
priority-group Create an ETS priority group.
qos-policy
set-pgid Configure the priority-group.
Create a QoS output policy to configure the ETS bandwidth allocation and scheduling for priority
traffic.
qos-policy-output policy-name ets
To remove the QoS output policy, use the
policy-name
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
If an error occurs in an ETS output-policy configuration, the configuration is ignored and the scheduler
and bandwidth allocation settings are reset to the ETS default values (all priorities are in the same ETS
priority group and bandwidth is allocated equally to each priority).
If an error occurs when a port receives a peer's ETS configuration, the port's configuration is reset to
the previously configured ETS output policy. If no ETS output policy was previously applied, the port
is reset to the default ETS parameters.
scheduler
bandwidth-percentage
Configure the method used to schedule priority traffic in port queues.
scheduler value
no qos-policy-output ets
Enter the policy name.
Maximum: 32 characters.
Schedule priority traffic in port queues.
Bandwidth percentage allocated to priority traffic in port queues.
command.