Dell Force10 MXL Blade Reference Manual page 52

line
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
motd-banner
Syntax
Defaults
Command Modes
Command
History
ping
Syntax
52 | Control and Monitoring
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
line { console 0 | vty number [ end-number ]}
console 0
Enter the keyword
The console option is <0-0>.
vty number
Enter the keyword
line for Telnet sessions.
The system supports 10 Telnet sessions.
end-number
(OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line to configure.
You can configure multiple lines at one time.
Not configured
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
You cannot delete a terminal connection.
access-class Restricts incoming connections to a particular IP address in an IP access control list
(ACL).
password Specifies a password for users on terminal lines.
show memory View current memory usage on the MXL switch.
Enable a Message of the Day (MOTD) banner to appear when you log in to the system.
motd-banner
Enabled on all lines.
LINE
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Test connectivity between the system and another device by sending echo requests and waiting for
replies.
ping [host | ip-address] [ count {number | continuous }] [datagram-size] [timeout] [source (ip
src-ipv4-address) | interface] [tos] [df-bit (y|n)] [validate-reply(y|n)] [ pattern pattern]
[sweep-min-size] [sweep-max-size] [sweep-interval] [ointerface (ip src-ipv4-address) | interface]
console 0
to configure the console port.
vty
followed by a number from 0 to 9 to configure a virtual terminal