Vlan-Stack Access; Vlan-Stack Compatible - Dell Force10 MXL Blade Reference Manual

Related
dei mark
Commands

vlan-stack access

Specify a Layer 2 port or port channel as an access port to the Stackable VLAN network.
Syntax vlan-stack access
To remove access port designation, use the no vlan-stack access command.
Defaults
Not configured.
Command Modes INTERFACE
Command
Version 8.3.16.1
History
Usage
Prior to enabling this command, to place the interface in Layer 2 mode, you must enter the switchport
Information
command.
To remove the access port designation, the port must be removed (use the no member interface
command) from all stackable VLAN-enabled VLANs.

vlan-stack compatible

Enable the Stackable VLAN feature on a VLAN.
Syntax vlan-stack compatible
To disable the stackable VLAN feature on a VLAN, use the no vlan-stack compatible command.
Defaults Not configured.
Command Modes
CONF-IF-VLAN
Command
Version 8.3.16.1
History
Usage You must remove the members prior to disabling the stackable VLAN feature.
Information
To view the stackable VLANs, use the show vlan command in EXEC Privilege mode. Stackable
VLANs contain members, designated by the M in the Q column of the command output.
Sets the DEI value on egress.
Introduced on MXL 10/40GbE Switch IO Module
Introduced on MXL 10/40GbE Switch IO Module
VLAN Stacking | 659