Rate Police - Dell Force10 MXL Blade Reference Manual

Command
Version 8.3.16.1
History
Usage The
Information
places traffic marked with a priority in the correct queue and processes that traffic according to its
queue.
When you set the priority for a Port Channel, the physical interfaces assigned to the Port Channel are
configured with the same value. You cannot assign
a Port Channel.

rate police

Police the incoming traffic rate on the selected interface.
Syntax rate police [ kbps ] committed-rate [ burst-KB ] [ peak [ kbps ] peak-rate [ burst-KB ]] [ vlan vlan-id ]
Parameters
kbps
committed-rate
burst-KB
peak peak-rate
vlan vlan-id
Defaults Granularity for commit ed-rate and peak-rate is Mbps unless the kbps option is used.
Command Mode
INTERFACE
Command
Version 8.3.16.1
History
Usage
Information
On one interface, you can configure the
police
commands specifying different VLANS.
After configuring VLANs in the
%Error: Specified VLANs overlap with existing config.
Introduced on MXL 10/40GbE Switch IO Module
dot1p-priority command changes the priority of incoming traffic on the interface. The system
Enter this keyword to specify the rate police in Kilobits per second (Kbps). On
MXL Switch make the following value a multiple of 64. The default granularity is
Megabits per second (Mbps).
Range: 0 to 40000000 (Kbps)
Enter a number as the bandwidth in Mbps.
Range: 0 to 10000
(OPTIONAL) Enter a number as the burst size in KB.
Range: 16 to 200000
Default: 50
(OPTIONAL) Enter the keyword
rate in Mbps.
Range: 0 to 10000
(OPTIONAL) Enter the keyword vlan followed by a VLAN ID to police traffic to
those specific VLANs.
Range: 1 to 4094
Introduced on MXL 10/40GbE Switch IO Module
Note:
Per Port rate police is supported for Layer 2 tagged and untagged switched traffic and
for Layer 3 traffic. Per VLAN rate police is supported on only tagged ports with Layer 2
switched traffic.
command for an interface. For each physical interface, you can configure three
dot1p-priority
peak
rate police command for a VLAN or you can configure the
rate police command, if this error message appears:
command to individual interfaces in
followed by a number to specify the peak
rate police
Quality of Service (QoS) | 463
rate