Dell Force10 MXL Blade Reference Manual page 319

Ftos command line reference guide for the mxl 10/40gbe switch io module
Hide thumbs Also See for Force10 MXL Blade:
Table of Contents

Advertisement

Example
Figure 15-21. show ip traffic Command Example (partial)
FTOS#show ip traffic
IP statistics:
Rcvd: 10021161 total, 3197480 local destination
2501 format errors, 390 checksum errors, 0 bad hop count
0 unknown protocol, 0 not a gateway
115 security failures, 0 bad options
Frags: 0 reassembled, 0 timeouts, 0 too big
0 fragmented, 0 couldn't fragment
Bcast: 6281 received, 0 sent; Mcast: 500 received, 0 sent
Sent: 6573260 generated, 0 forwarded
3830 encapsulation failed, 0 no route
ICMP statistics:
Rcvd: 0 format errors, 0 checksum errors, 0 redirects, 3 unreachable
0 echo, 0 echo reply, 0 mask requests, 0 mask replies, 0 quench
0 parameter, 0 timestamp, 0 info request, 0 other
Sent: 0 redirects, 1 unreachable, 0 echo, 0 echo reply
0 mask requests, 0 mask replies, 0 quench, 0 timestamp
0 info reply, 0 time exceeded, 0 parameter problem
UDP statistics:
Rcvd: 2938110 total, 14 checksum errors, 1 no port
0 short packets, 0 bad length, 1883908 no port broadcasts, 0 socket full
Sent: 329731 total, 1883908 forwarded broadcasts
--More--
Table 15-11. show ip traffic output definitions
Keyword
unknown protocol...
not a gateway...
security failures...
bad options...
Frags:
... reassembled
... timeouts
... too big
... couldn't fragment
...encapsulation failed
Rcvd:
...short packets
...bad length
...no port broadcasts
...socket full
Definition
No receiver for these packets. Counts those packets whose protocol type field is not
recognized by FTOS.
Packets can not be routed; host/network is unreachable.
Counts the number of received unicast/multicast packets that could not be forwarded
due to:
route not found for unicast/multicast; ingress interfaces do not belong to the
destination multicast group
destination IP address belongs to reserved prefixes; host/network unreachable
Unrecognized IP option on a received packet.
IP fragments received.
Number of IP fragments that were reassembled.
Number of times a timer expired on a reassembled queue.
Number of invalid IP fragments received.
Number of packets that could not be fragmented and forwarded.
Counts those packets which could not be forwarded due to ARP resolution failure.
FTOS sends an arp request prior to forwarding an IP packet. If a reply is not
received, FTOS repeats the request three times. These packets are counted in
encapsulation failed.
The number of bytes in the packet are too small.
The length of the packet was not correct.
The incoming broadcast/multicast packet did not have any listener.
The applications buffer was full and the incoming packet had to be dropped.
IPv4 Routing | 319

Advertisement

Table of Contents
loading

Table of Contents