Dell Force10 MXL Blade Reference Manual page 44

Example
enable
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
enable optic-info-update interval
Syntax
Parameters
Defaults
44 | Control and Monitoring
Figure 4-4. do Command Example
FTOS(conf-if-te-5/0)#do clear counters
Clear counters on all interfaces [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do clear logging
Clear logging buffer [confirm]
FTOS(conf-if-te-5/0)#
FTOS(conf-if-te-5/0)#do reload
System configuration has been modified. Save? [yes/no]: n
Proceed with reload [confirm yes/no]: n
FTOS(conf-if-te-5/0)#
Enter EXEC Privilege mode or any other privilege level configured. After entering this command, you
may need to enter a password.
enable [ level ]
level
(OPTIONAL) Enter a number for a privilege level of FTOS.
Range: 0 to 15.
Default: 15
15
EXEC
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Users entering EXEC Privilege mode or any other configured privilege level can access configuration
commands. To protect against unauthorized access, use the
password for the enable command at a specific privilege level. If no privilege level is specified, the
default is privilege level 15.
enable password
Configures a password for the
Enable polling intervals of optical information updates for SNMP.
enable optical-info-update interval seconds
To disable optical power information updates, use the no enable optical-info-update interval
command.
interval seconds Enter the keyword
Range: 120 to 6000 seconds
Default: 300 seconds (5 minutes)
Disabled
enable password
enable
command and to access a privilege level.
interval
followed by the polling interval in seconds.
command to configure a