Show Lacp - Dell Force10 MXL Blade Reference Manual

Related

show lacp

Commands
show interfaces port-channel
show lacp
Display the LACP matrix.
Syntax
show lacp port-channel-number [ sys-id | counters ]
Parameters
port - channel-number
sys-id
counters
Command Modes
EXEC
EXEC Privilege
Command
Version 8.3.16.1
History
Example 1 Figure 17-2. show lacp port-channel-number Command Example
FTOS#show lacp 1
Port-channel 1 admin up, oper up, mode lacp
Actor System ID:
Partner System ID:
A - Active LACP, B - Passive LACP, C - Short Timeout, D - Long Timeout
E - Aggregatable Link, F - Individual Link, G - IN_SYNC, H - OUT_OF_SYNC
I - Collection enabled, J - Collection disabled, K - Distribution enabled L - Distribution disabled,
M - Partner Defaulted, N - Partner Non-defaulted, O - Receiver is in expired state,
P - Receiver is not in expired state
Port Te 10/6 is enabled, LACP is enabled and mode is lacp
Actor Admin: State ACEHJLMP Key 1
Oper: State ACEGIKNP Key 1
Partner Admin: State BDFHJLMP Key 0
Oper: State BCEGIKNP Key 1
FTOS#
Example 2 Figure 17-3. show lacp sys-id Command Example
FTOS#show lacp 1 sys-id
Actor
Partner System ID:
FTOS#
Introduced on MXL 10/40GbE Switch IO Module
Priority 32768, Address 0001.e800.a12b
Priority 32768, Address 0001.e801.45a5
Actor Admin Key 1, Oper Key 1, Partner Oper Key 1
LACP LAG 1 is an aggregatable link
System ID: Priority 32768, Address 0001.e800.a12b
Priority 32768, Address 0001.e801.45a5
Displays the LACP information.
Displays information on configured Port Channel groups.
Enter a port-channel number:
Range: 1 to 128
(OPTIONAL) Enter the keyword
system.
(OPTIONAL) Enter the keyword
Priority 128
Priority 128
Priority 0
Priority 128
sys-id
and the value that identifies a
counters
to display the LACP counters.
Link Aggregation Control Protocol (LACP) | 335