Management Route; Ip Unreachables - Dell Force10 MXL Blade Reference Manual

Defaults Enabled.
Command Modes
CONFIGURATION
Command
Version 8.3.16.1
History

ip unreachables

Enable the generation of Internet Control Message Protocol (ICMP) unreachable messages.
ip unreachables
Syntax
To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults Disabled
Command Modes INTERFACE
Command
Version 8.3.16.1
History

management route

Configure a static route that points to the Management interface or a forwarding router.
Syntax management route { ipv4-address } /mask { forwarding-router-address | managementethernet }
Parameters
ipv4-address
{
forwarding-router-address
managementethernet
Defaults
Not configured.
Command Modes CONFIGURATION
Command
Version 8.3.16.1
History
Usage
When a static route (or a protocol route) overlaps with Management static route, the static route (or a
Information
protocol route) is preferred over the Management Static route. Also, Management static routes and the
Management Connected prefix are not reflected in the hardware routing tables. Separate routing tables
are maintained for IPv4 management routes. This command manages both tables.
Related
interface ManagementEthernet
Commands
Introduced on MXL 10/40GbE Switch IO Module
Introduced on MXL 10/40GbE Switch IO Module
/mask
} Enter an IPv4 address (A.B.C.D) followed by the prefix-length for
the IP address of the management interface.
Enter an IPv4 address of a forwarding router.
Enter the keyword
interface.
Introduced on MXL 10/40GbE Switch IO Module
Configures the Management port on the system.
managementethernet
for the Management
IPv4 Routing | 305