Show Lldp Neighbors; Show Lldp Statistics - Dell Force10 MXL Blade Reference Manual

Command Modes INTERFACE (conf-if-interface-lldp)
Command
Version 8.3.16.1
History
Usage
You must enable LLDP globally from CONFIGURATION mode before you can configure it on an
Information
interface. This command places you in LLDP mode on the interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global configurations. When
you execute the no protocol lldp from INTERFACE mode, interfaces begin to inherit the configuration
from global LLDP CONFIGURATION mode.

show lldp neighbors

Display LLDP neighbor information for all interfaces or a specified interface.
Syntax show lldp neighbors
Parameters
interface
detail
Defaults none
Command Modes
EXEC Privilege
Command
Version 8.3.16.1
History
Example Figure 19-1. show lldp neighbors Command Example
R1(conf-if-te-1/31)#do show lldp neighbors
Usage
Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.
Information

show lldp statistics

Display the LLDP statistical information.
show lldp statistics
Syntax
Defaults
none
[ interface ] [ detail ]
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
slot/port information.
(OPTIONAL) Enter the keyword
LLDP tx and rx counters.
Loc PortID Rem Host Name
-------------------------------------------------------------------------
TenGig 1/21 R2
TenGig 1/31 R3
Introduced on MXL 10/40GbE Switch IO Module
detail
to display all the TLV information, timers, and
Introduced on MXL 10/40GbE Switch IO Module
Rem Port Id
TenGigabitEthernet 2/11
TenGigabitEthernet 3/11
tenGigabitEthernet
fortyGigE
followed by the
Rem Chassis Id
00:01:e8:06:95:3e
00:01:e8:09:c2:4a
Link Layer Discovery Protocol (LLDP) | 361