Related
Commands
snmp trap link-status
Syntax
Defaults
Command Modes
Command
History
Usage
Information
Syslog Commands
594
|
Simple Network Management Protocol (SNMP) and Syslog
show running-config snmp
Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.
snmp trap link-status
To disable sending link trap messages, use the no snmp trap link-status command.
Enabled.
INTERFACE
Version 8.3.16.1
Introduced on MXL 10/40GbE Switch IO Module
If the interface is expected to flap during normal usage, you can disable this command.
The following commands allow you to configure logging functions on all Dell Force10 switches:
•
clear logging
•
default logging buffered
•
default logging console
•
default logging monitor
•
default logging trap
•
logging
•
logging buffered
•
logging console
•
logging facility
•
logging history
•
logging history size
•
logging monitor
•
logging on
•
logging source-interface
•
logging synchronous
•
logging trap
•
show logging
•
show logging driverlog stack-unit
•
terminal monitor
Displays the SNMP running configuration.