Banner Motd - Dell Force10 MXL Blade Reference Manual

Example
Related
Commands

banner motd

Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
40 | Control and Monitoring
Figure 4-2. banner login Command Example
FTOS(conf)#banner login ?
keyboard-interactive
LINE
character
FTOS(conf)#no banner login ?
keyboard-interactive
<cr>
FTOS(conf)#banner login keyboard-interactive
Enter TEXT message.
This is the banner%
FTOS(conf)#end
FTOS#exit
13d21h9m: %STKUNIT0-M:CP %SEC-5-LOGOUT: Exec session is terminated for user on
line console
This is the banner
Dell Force10 con0 now available
Press RETURN to get started.
13d21h10m: STKUNIT0-M:CP %SEC-5-LOGIN_SUCCESS: Login successful for user
console
This is the banner
banner exec Sets a banner to be displayed when you enter EXEC Privilege mode.
banner motd Sets a Message of the Day banner.
Set a Message of the Day (MOTD) banner.
banner motd c line c
c
Enter a delineator character to specify the limits of the text banner. In the above figures, the %
character is the delineator character.
line
Enter a text string for your message of the day banner message ending the message with your
delineator.
In the example figures above, the delineator is a percent character (%).
No banner is configured.
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
A MOTD banner message is displayed only in EXEC Privilege mode after entering the enable
command followed by the password. These banners are not displayed to users in EXEC (non-privilege)
mode.
banner exec
banner login
Press enter key to get prompt
c banner-text(max length 255) c, where 'c' is a delimiting
Prompt will be displayed by default
End with the character '%'.
Sets a banner to be displayed when you enter the EXEC Privilege mode.
Sets a banner to be displayed after successful login to the system.
on line