Dell Force10 MXL Blade Reference Manual page 391

Command
Version 8.3.16.1
History
Example Figure 21-1. debug ip ospf process-id packet Command Example
FTOS#debug ip ospf 1 packet
OSPF process 1, packet debugging is on
FTOS#
08:14:24 : OSPF(100:00):
Xmt. v:2 t:1(HELLO) l:44 rid:192.1.1.1
Table 21-1. debug ip ospf process-id packet Output Descriptions
Field
8:14
OSPF
v:
t:
l:
rid:
aid:
chk:
aut:
auk:
keyid:
to:
dst:
netmask:
pri:
Introduced on MXL 10/40GbE Switch IO Module
aid:0.0.0.1 chk:0xa098 aut:0 auk: keyid:0 to:TenGig 4/3 dst:224.0.0.5
netmask:255.255.255.0 pri:1 N-, MC-, E+, T-,
hi:10 di:40 dr:90.1.1.1 bdr:0.0.0.0
Description
Displays the time stamp.
Displays the OSPF process ID: instance ID.
Displays the OSPF version. FTOS supports version 2 only.
Displays the type of packet sent:
• 1 - Hello packet
• 2 - database description
• 3 - link state request
• 4 - link state update
• 5 - link state acknowledgement
Displays the packet length.
Displays the OSPF router ID.
Displays the Autonomous System ID.
Displays the OSPF checksum.
States if OSPF authentication is configured. One of the following is listed:
• 0 - no authentication configured
• 1 - simple authentication configured using the
• 2 - MD5 authentication configured using the
If the ip ospf authentication-key
If the ip ospf message-digest-key
Displays the interface to which the packet is intended.
Displays the destination IP address.
Displays the destination IP address mask.
Displays the OSPF priority
ip ospf authentication-key
ip ospf message-digest-key
command is configured, this field displays the key used.
command is configured, this field displays the MD5 key
Open Shortest Path First (OSPFv2) | 391
command)
command.