Dell Force10 MXL Blade Reference Manual page 250

Related
Commands
intf-type cr4 autoneg
Syntax
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
keepalive
Syntax
250 | Interfaces
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not supported in
VLANs. IP ACLs are supported. Refer to
interface
interface loopback
interface null
interface port-channel
show vlan
shutdown
tagged
untagged
Set the interface type as CR4 with auto-negotiation enabled.
intf-type cr4 autoneg
If intf-type cr4 autoneg is configured, use the no intf-type cr4 autoneg command to set the interface
type as cr4 with autonegotiation disabled.
Not configured
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
If interface type is configured as CR4 with auto-negotiation enabled, then the peer should also be
configured as CR4 with auto-negotiation. Many DAC cable link issues can be resolved by setting the
interface type as CR4.
interface
interface loopback
interface null
interface port-channel
Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
keepalive [ seconds ]
To stop sending keepalive packets, use the no keepalive command.
Chapter 6, Access Control Lists
Configures a physical interface.
Configures a loopback interface.
Configures a null interface.
Configures a port channel group.
Displays the current VLAN configuration on the switch.
Disables/Enables the VLAN.
Adds a Layer 2 interface to a VLAN as a tagged interface.
Adds a Layer 2 interface to a VLAN as an untagged interface.
Configures a physical interface.
Configures a loopback interface.
Configures a null interface.
Configures a port channel group.
(ACL).