Logging Synchronous; Logging Source-Interface - Dell Force10 MXL Blade Reference Manual

logging source-interface

Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Syntax logging source-interface interface
To disable this command and return to the default setting, use the no logging source-interface
command.
Parameters
interface
Defaults
Not configured.
Command Modes CONFIGURATION
Command
Version 8.3.16.1
History
Usage
Syslog messages contain the IP address of the interface used to egress the router. By configuring the
Information
logging source-interface
configured.
Related
logging
Commands

logging synchronous

Synchronize unsolicited messages and FTOS output.
Syntax logging synchronous [ level level | all ] [ limit number-of-buffers ]
To disable message synchronization, use the no logging synchronous [ level level | all ] [ limit
number-of-buffers
Parameters
all
level level
Enter the following keywords and slot/port or number information:
• For Loopback interfaces, enter the keyword
zero (0) to 16383.
• For a Port Channel interface, enter the keyword
Range: 1-128
• For a Ten Gigabit Ethernet interface, enter the keyword
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
slot/port information.
• For VLAN interface, enter the keyword
Introduced on MXL 10/40GbE Switch IO Module
command, the Syslog packets contain the IP address of the interface
Enables the logging to another device.
] command.
Enter the keyword
Enter the keyword
number indicates a low severity level and visa versa.
Range: 0 to 7.
Default: 2
Simple Network Management Protocol (SNMP) and Syslog | 601
loopback
followed by a number from
port-channel
TenGigabitEthernet
fortyGigE
vlan
followed by a number from 1 to 4094.
all
to ensure that all levels are printed asynchronously.
level
followed by a number as the severity level. A high
followed by a number:
followed by the