Protocol Spanning-Tree Mstp - Dell Force10 MXL Blade Reference Manual

protocol spanning-tree mstp

Enter MULTIPLE SPANNING TREE mode to enable and configure the multiple spanning tree group.
Syntax protocol spanning-tree mstp
To disable the multiple spanning tree group, use the no protocol spanning-tree mstp command.
Defaults
Not configured.
Command Modes CONFIGURATION
Command
Version 8.3.16.1
History
Example Figure 20-2. protocol spanning-tree mstp Command Example
FTOS(conf)#protocol spanning-tree mstp
FTOS(conf-mstp)#no disable
Usage
MSTP is not enabled when you enter the MULTIPLE SPANNING TREE mode. To enable MSTP
Information
globally on the switch, enter
For more information about the multiple spanning tree protocol, refer to the FTOS Configuration
Guide.
Related
disable
Commands
revision
The revision number for the multiple spanning tree configuration
Syntax revision range
To return to the default values, use the no revision command.
Parameters
range
Defaults
0
Command Modes MULTIPLE SPANNING TREE
Command
Version 8.3.16.1
History
Usage For two MSTP switches to be within the same MST region, the switches must share the same revision
Information
number.
Related
msti
Commands
name
Introduced on MXL 10/40GbE Switch IO Module
no disable while in MULTIPLE SPANNING TREE mode.
Disables MSTP.
Enter the revision number for the MST configuration.
Range: 0 to 65535
Default: 0
Introduced on MXL 10/40GbE Switch IO Module
Maps the VLAN(s) to an MST instance
Assigns the region name to the MST region.
Multiple Spanning Tree Protocol (MSTP) | 377