Dell Force10 MXL Blade Reference Manual page 160

Related
Commands
dcb-policy output stack-unit stack-ports all
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
dcb stack-unit all pfc-buffering pfc-port-count pfc-queues
Syntax
160 | Data Center Bridging
To remove an ETS output policy from an interface, enter the no dcb-policy output policy-name
command. ETS is enabled by default with the default ETS configuration applied (all dot1p priorities in
the same group with equal bandwidth allocation).
dcb-output Create a DCB output policy.
Apply the specified DCB output policy on all ports of the switch stack or a single stacked switch.
dcb-policy output stack-unit {all | stack-unit-id} stack-ports all dcb-output-policy-name
To remove all DCB input policies applied to the stacked ports, use the
all command.
To remove only the DCB input policies applied to the specified switch, use the
stack-unit command.
stack-unit-id
dcb-output-policy-
name
none
CONFIGURATION
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
The dcb-policy output stack-unit all
stack-unit-id configurations. Similarly, a
overwrites any previous dcb-policy output stack-unit all
You can apply a DCB output policy with ETS configuration to all stacked ports in a switch stack or an
individual stacked switch. You can apply different DCB output policies to different stack units.
dcb-policy input stack-unit
stack-ports all
Configure the PFC buffer for all switches in the stack.
dcb stack-unit all pfc-buffering pfc-port-count {1-56} pfc-queues {1-2}
To remove the configuration for the PFC buffer on all switches in the stack, use the
all pfc-buffering pfc-port-count pfc-queues
Enter the stack unit identification.
Enter the policy name for the DCB output policy.
command overwrites any previous
dcb-policy output stack-unit stack-unit-id
Apply the specified DCB input policy.
command.
no dcb-policy output stack-unit
no dcb-policy output
dcb-policy output stack-unit
command
configuration.
no dcb stack-unit