Igmp Mrouter Interface; Interface Port-Channel; Ip Access-Group (Port Channel) - Dell Force10 S2410-01-10GE-24P Command Reference Manual

igmp mrouter
This command is available in the Interface Port Channel Config mode.
See

igmp mrouter interface

This command is available in the Interface Port Channel Config mode.
See

interface port-channel

This command invokes the Interface Port Channel Config mode, along with creating a port channel
(LAG) if one with the designated number does not exist.
The no version of this command deletes a port channel (LAG).
[no] interface port-channelr 1-128
Syntax
The 1-128 field is an integer that uniquely identifies the port channel. The maximum number of
supported port channels is 128, out of which, at most, six dynamic port channels are recommended.
Mode
Global Config
Command
Version 2.5.1.0
History
Related
channel-member
Commands
show interfaces
port-channel
speed

ip access-group (port channel)

This command attaches a specified access control list (ACL) to the port channel selected by the
interface port-channel command.
ip access-group 1–199 [ 1-4294967295 ]
Syntax
igmp mrouter on page 277
igmp mrouter interface enable on page 278
Note:
Before including a port in a port channel, set the physical mode of the port. See the
speed command.
Modified: Before 2.5.1, the command syntax was
number of supported port channels was 32.
Add a port or range of ports to the selected LAG. LAG ports must be physical ports,
not other LAGs.
Displays an overview of all port channels (LAGs) on the switch or details on the
selected LAG.
Set the physical mode of the port.
in the IGMP chapter.
in the IGMP chapter.
desC6Oi ooEg
name.
The previous
LAG/Port Channel Commands | 295