Garp Timers - Dell Force10 MXL Blade Reference Manual

garp timers

Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
Related
Commands
220 | GARP VLAN Registration (GVRP)
Set the intervals (in milliseconds) for sending GARP messages.
garp timers { join | leave | leave-all }
To return to the previous setting, use the no garp timers { join | leave
join Enter the keyword
time.
Range: 100 to 147483647 milliseconds
Default: 200 milliseconds
Note: Designate the milliseconds in multiples of 100
leave
Enter the keyword
time.
Range: 100 to 2147483647 milliseconds
Default: 600 milliseconds
Note: Designate the milliseconds in multiples of 100
leave-all
Enter the keyword
leave-all time.
Range: 100 to 2147483647 milliseconds
Default: 1000 milliseconds
Note: Designate the milliseconds in multiples of 100
Default as above
CONFIGURATION-GVRP
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Join Timer—Join messages announce the willingness to register some attributes with other
participants. Each GARP application entity sends a Join message twice, for reliability, and uses a join
timer to set the sending interval.
Leave Timer—Leave announces the willingness to de-register with other participants. Together with
the Join, Leave messages help GARP participants complete attribute reregistration and de-registration.
Leave Timer starts upon receipt of a leave message sent for de-registering some attribute information.
If a join message is not received before the leave time expires, the GARP application entity removes
the attribute information as requested.
Leave All Timer—The Leave All Timer starts when a GARP application entity starts. When this timer
expires, the entity sends a leave-all message so that other entities can re-register their attribute
information. Then, the leave-all time begins again.
show garp timers
join
followed by the number of milliseconds to configure the join
leave
followed by the number of milliseconds to configure the leave
leave-all
followed by the number of milliseconds to configure the
Displays the current GARP times.
| leave-all } command.