Dell Force10 MXL Blade Reference Manual page 92

description
Syntax
Parameters
Defaults
Command Modes
Command
History
remark
Syntax
Parameters
Defaults
Command Modes
Command
History
Usage
Information
92 | Access Control Lists (ACL)
Configure a short text string describing the ACL.
description text
text
Enter a text string up to 80 characters long.
Not enabled.
CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Enter a description for an ACL entry.
remark [ remark-number ] [ description ]
remark-number
description
Not configured
CONFIGURATION-IP ACCESS-LIST-STANDARD
CONFIGURATION-IP ACCESS-LIST-EXTENDED
CONFIGURATION-MAC ACCESS LIST-STANDARD
CONFIGURATION-MAC ACCESS LIST-EXTENDED
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
The remark command is available in each ACL mode. You can configure up to 4294967290 remarks
in a given ACL.
The following example shows the use of the remark command twice within CONFIGURATION-IP
ACCESS-LIST-STANDARD mode. Here, the same sequence number was used for the remark and for
an associated ACL rule. The remark precedes the rule in the running-config because it is assumed that
the remark is for the rule with the same sequence number, or the group of rules, that follow the remark.
Enter the remark number. Note that you can use the same sequence number
for the remark and an ACL rule.
Range: 0 to 4294967290
Enter a description of up to 80 characters.