Dell Force10 MXL Blade Reference Manual page 608

Parameters
Defaults
Command Modes
Command
History
Usage
Information
storm-control broadcast (Interface)
Syntax
Parameters
Defaults
Command Modes
Command
History
storm-control multicast (Configuration)
Syntax
Parameters
Defaults
Command Modes
Command
History
608 | Storm Control
packets_per_second
none
CONFIGURATION (conf)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2 broadcast traffic is treated
as unknown-unicast traffic.
Configure the packets per second of broadcast traffic to be limited on the interface.
storm-control broadcast [packets_per_second] in
To disable broadcast storm control on the interface, use the no storm-control broadcast
[packets_per_second] in command.
packets_per_second
none
INTERFACE (conf-if-interface-slot/port)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Configure the packets per second (pps) of multicast traffic.
storm-control multicast [packets_per_second] in
To disable storm-control for multicast traffic into the network, use the no storm-control multicast
[packets_per_second] in command.
packets_per_second
none
CONFIGURATION (conf)
Version 8.3.16.1 Introduced on MXL 10/40GbE Switch IO Module
Enter the packets per second of broadcast traffic allowed from the network.
Range: 0 to 33554368.
Enter the packets per second of broadcast traffic allowed from the network.
Range: 0 to 33554368
Enter the packets per second of multicast traffic allowed from the network
in
followed by the keyword .
Range: 0 to 33554368