Dell Force10 MXL Blade Reference Manual page 283

Ftos command line reference guide for the mxl 10/40gbe switch io module

Hide thumbs Also See for Force10 MXL Blade:

Table of Contents

Table 14-10. show interfaces port-channel Command Example Fields (continued)

Rate information...

Time since...

Figure 14-43. show interfaces port-channel brief Command Example

FTOS#show int po 1 brief

Codes: L - LACP Port-channel

Table 14-11. show interfaces port-channel brief Command Example Fields

Displays the type and number of packets sent out the interface. This

information is displayed over three lines.

Displays the traffic rate information into and out of the interface. Traffic

rate is displayed in bits and packets per second.

Displays the time since the last change in the configuration of this

Lists the port channel number.

Lists the mode:

L3 - for Layer 3

L2 - for Layer 2

Displays the status of the port channel.

down - if the port channel is disabled (shutdown)

up - if the port channel is enabled (no shutdown)

Displays the age of the port channel in hours:minutes:seconds.

Lists the interfaces assigned to this port channel.

Displays the status of the physical interfaces (

In Layer 2 port channels, an * (asterisk) indicates which interface is the

primary port of the port channel. The primary port sends out interface

In Layer 3 port channels, the primary port is not indicated.

Displays the LACP matrix.

Interfaces | 283