Mask-Val - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

mask-val

[ no ] mask-val value
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Color Mark Profile Configuration mode added in JUNOSe Release 7.2.0.
Sets the mask value. For rate limits, use this command with the committed-action,
Description
conformed-action, and exceeded-action commands. For color-mark profiles, use the
mask-val command in Color Mark Profile Configuration mode. The no version restores
the default value, 255.
Options
Color Mark Profile Configuration, Rate Limit Profile Configuration
Mode
Related Topics
value Mask value in the range 0–255. Use the following mask values to set the
appropriate bits in the ToS field of the IP packet header:
IP Precedence 0xE0 (three most significant bits)
DS Field 0xFC (six significant bits)
TOS (IP) or Traffic Class field (IPv6) 0xFF (default)
Creating a Two-Rate Rate-Limit Profile
Setting the Mask Value for MPLS Rate-Limit Profiles
Setting the Mask Value for IP and IPv6 Rate-Limit Profiles
Chapter 13: M Commands
1257
mask-val